Telemetry; Temperature sensor readings. Typically T1, T2
Glossary
Abbreviation for ‘Trim Aileron Left’ physical switch position used in Special Functions
Abbreviation for ‘Trim Aileron Right’ physical switch position used in Special Functions
Abbreviation for ‘Trim Elevator Down’ physical switch position used in Special Functions
A catch-all term for passing performance information from the model back to the RC pilot. This information can be quite extensive, and include RSSI, various voltages, GPS position, altitude, etc. Not all FrSky receivers are telemetry capable, but all of … Continue reading
SEE: Batt, SWR, RSSI, A1, A2, Alt, Rpm, Fuel, T1, Speed, Dist, GPS Alt, Cell, Cells, Vfas, Curr, Cnsp, Power, Accx, Accy, Accz
Abbreviation for ‘Trim Elevator Up’ physical switch position used in Special Functions
A trigger that starts a Timer and counts up as a percentage of the full stick range. At full throttle it counts second for second; at half throttle every other second; at about 10% it counts one second of flight … Continue reading
A switch set up on a RC model Tx used to stop an internal combustion motor or an electric motor.
A switch in a RC helicopter Tx set up that sets a heli throttle to low value regardless of any other input. Often seen as another flight mode employing a separate pitch curve.
A check box in Model Set Up to ensure correct operation of throttle-based functions and timers for set ups in which full throttle is in the down position. CAUTIONS: This check box does not reverse the direction of the throttle … Continue reading
Restricts trim input to only the idle portion of stick throw unlike the usual offset with affects both ends of the throw. Useful in wet fuel set ups to avoid overdriving the throttle servo. Useful for electric power set ups to keep … Continue reading
An audio alert upon turning on power to the Taranis if the throttle control is not in the idle position. A safety feature to avoid starting an engine or motor with the throttle advanced.
A trigger to start a Timer. Starts the Timer whenever the throttle stick moves off idle, and stops the timer when the throttle returns to idle. Trigger action is unaffected by throttle trim.
A trigger that starts a Timer the first time throttle is advanced from idle. The timer continues to run even when the throttle returns to idle. Trigger action is unaffected by throttle trim. … Continue reading
A timed pulse trigger function which takes two time parameters (active, inactive) in seconds.
There are 2 fully programmable timers (Timer1 and Timer2), that can count either up or down. If the value is set to 00:00 they will count up from 0. If set to a time, they count down from the preset value. The … Continue reading
Timer1, Timer2 See also Timer
Abbreviation for Timer1 and Timer2 in the Telemetry menu. See Timer and Timers … Continue reading
8 physical switches on the transmitter; SA↓, SA-, SA↑, SB↓, SB-, SB↑, …. SG↓, SG-, SG↑, SH↓, SH↑ denotes switch in up(↑), down(↓), or middle (-) position SH↓s momentary Short-Press SH↓l momentary Long-Press … Continue reading