A trigger that starts a Timer and counts up as a percentage of the full stick range. At full throttle it counts second for second; at half throttle every other second; at about 10% it counts one second of flight … Continue reading
Glossary
A switch set up on a RC model Tx used to stop an internal combustion motor or an electric motor.
A switch in a RC helicopter Tx set up that sets a heli throttle to low value regardless of any other input. Often seen as another flight mode employing a separate pitch curve.
A check box in Model Set Up to ensure correct operation of throttle-based functions and timers for set ups in which full throttle is in the down position. CAUTIONS: This check box does not reverse the direction of the throttle … Continue reading
Restricts trim input to only the idle portion of stick throw unlike the usual offset with affects both ends of the throw. Useful in wet fuel set ups to avoid overdriving the throttle servo. Useful for electric power set ups to keep … Continue reading
An audio alert upon turning on power to the Taranis if the throttle control is not in the idle position. A safety feature to avoid starting an engine or motor with the throttle advanced.
A trigger to start a Timer. Starts the Timer whenever the throttle stick moves off idle, and stops the timer when the throttle returns to idle. Trigger action is unaffected by throttle trim.
A trigger that starts a Timer the first time throttle is advanced from idle. The timer continues to run even when the throttle returns to idle. Trigger action is unaffected by throttle trim. … Continue reading