↓

OpenTX University

A Brave New World

OpenTX University
Home Menu ↓
Skip to primary content
Skip to secondary content
  • Home
    • Site Map
  • Version 2
    • v2.1 Resources
    • v2.2 Resources
  • Undergraduate Courses
    • Introduction
      • How RC Works
      • Open Source Basics
      • OpenTX vs OpenTX Comp.
      • Why Upgrade?
    • Fund. of OpenTX (Win)
      • First Steps
      • Checking Out Taranis
      • Intro. to Zadig
      • Using Zadig
      • OpenTX Companion
      • Installing OpenTX Comp.
      • Working With Log Files
      • Configure Google Earth & Companion
      • Flashing OpenTX
      • Boot Loaders
    • Fund. of OpenTX (Mac)
      • Intro to DFU
      • Installing DFU
      • OpenTX Companion (Mac)
      • Installing OpenTX Comp. (Mac)
    • Radio Setup
      • Beginning Radio Setup
      • General Radio Settings
    • Taranis Prog. Review
    • Basic Plane Set Up w/Taranis
      • Basic Airplane Introduction
      • Important Info on Servo Travel
      • Startup Warnings, Main Screens, and Model Selection (1/13)
      • Model Set Up (2/13)
      • Skipping Lightly Through Heli & Flight Modes for Quality Time in Inputs (5/13)
      • Mixer (6/13)
      • Servos (7/13)
      • Control Chain Takeaways (What Goes Where)
      • Skipping forward to Telemetry (13/13)
      • Wrap Up
    • Non Fixed Wing
      • Helicopter
        • Helicopter Model Basics
        • Basic Heli Part 1: Setup
        • Basic Heli Part 2: Mixers
        • Basic Heli Part 3: Curves
        • OpenTX Heli Flight Modes
        • CCPM for Taranis
      • Multirotors
        • OpenTX and Multirotors
        • Using Flight Controllers
        • CleanFlight PID Tuning
    • Lua
      • Introduction to Lua Scripts
      • Beginning Model Scripting
  • Continuing Education
    • Introduction to Antennas
    • Creating A Model Image
    • Logical Switch Functions
    • Taranis SD Card Addendum
    • Taranis SD Card Storage
  • Glossary
  • OpenTX Manual
Home

Variable

A C D F G H M P S T V
Cn Co Cu

Cnsp

Posted on July 4, 2014 by John CaseJuly 4, 2014

Total mAh used as reported by current sensor. mAh measured

Posted in Variable

Comparison Function Variables

Posted on July 4, 2014 by John CaseJuly 4, 2014

a, b and d – use assignable to control hardware … Continue reading →

Posted in Variable

Curr

Posted on July 6, 2014 by John CaseJuly 6, 2014

Current in Amps as reported by the current sensor.

Posted in Variable

Curr+

Posted on July 6, 2014 by John CaseJuly 6, 2014

Maximum current in Amps as reported by the current sesnor.

Posted in Variable
©  2014 - OpenTXU               All rights reserved.
↑