Video

1.1.03 Welcome to Taranis, Part 3 Binding a D Series Receiver

“Welcome to Taranis, Part 3 Binding a D Series Receiver” (March 12, 2014) by Mark Harrison

Tags: Binding, D series receivers

This 1:07 minute video is the third in Mark’s series to get you up to speed with Taranis as soon as possible.  Published when Companion 9X in use.  He demonstrates binding the D series receivers to the Taranis.

Video Contents:

  • Note polarity on receiver
  • Remove or disable props
  • On RX power on while pressing failsafe/bind button
  • On TX go to model setup screen
  • Select mode D8, channel range CH1-8
  • Select bind, hear beep
  • Disconnect and reconnect power to RX
  • TX/RX bound, controls should be operational

 

Video

1.1.02 Welcome to Taranis, Part 2: Binding an X Series Receive

“Welcome to Taranis, Part 2: Binding an X Series Receiver” (March 12, 2014) by Mark Harrison

Tags: Binding, X8R, X6R

This 2:29 minute video is the second in Mark’s series to get you up to speed with Taranis as soon as possible.  Published when Companion 9X in use.  He demonstrates binding the X8R and X6R receivers to the Taranis.

Video Contents:

  • Note polarity on receiver
  • Remove or disable props
  • On RX power on while pressing failsafe/bind button
  • On TX go to model setup screen
  • Select mode D16, channel range CH1-8
  • Select bind
  • Disconnect and reconnect power to RX
  • TX/RX bound, controls should be operational

 

Video

Binding a Variety of Receivers with the FrSKY Taranis

Binding a Variety of Receivers with the FrSKY Taranis” (Nov 2013) by Scott Page

Tags: Binding, D8R-II, D4R-II, V8FR-II, Delta-8, X8R

Binding the different FrSky receivers with the Taranis.

Index of video topics:
00:00 – 00:23 D8R-II, D4R-II, V8FR-II, Delta-8, and X8R
00:23 – 01:23 X8R binding procedure
01:23 – 02:26 D4R-II binding procedure
02:27 – 03:08 D8R-II binding procedure
03:09 – 04:09 V8FR-II binding procedure
04:10 – 06:44 Delta-8 binding procedure

Video

What to do first when you get your FrSKY Taranis – a little bit of this and a little bit of that

“What to do first when you get your FrSKY Taranis – a little bit of this and a little bit of that” (Jul 2, 2013) by Scott Page

Tags: Bind, Calibrate, USB Port, Flash

Initial steps when you get the new transmitter.

Index of video topics:
00:10 – 01:35 Deleting old model tip
01:35 – 02:30 Turn on TX and check all switches
02:30 – 03:08 Check pots and sliders
03:08 – 04:10 Calibrate TX sticks
04:10 – 06:00 Calibrate battery
06:00 – 06:33 USB Port
06:33 – 08:35 Flashing firmware with C9X (1)
08:35 – 09:30 Taranis computer folder strategy
09:30 – 10:00 Flashing firmware with C9X (2)
10:00 – 12:10 Bind RX to the Taranis