2.2.06 FrSky TARANIS Radio – Adding and using custom sound by Painless360 June 2015 (#6 of 13)

– Introduction (0:02)
– Demo of sound on the radio (1:28)
– Options to create and add custom sounds (2:18)
– Overview of the Amber sound pack (5:08)
– Adding the sounds to your radio (7:48)
– Setting up the radio to play the new sounds (10:32)
– Setting up OpenTX Companion to use the new sounds too (13:43)
– Summary (16:48)

Tags: Sound, Amber, Painless360


Comments

2.2.06 FrSky TARANIS Radio – Adding and using custom sound by Painless360 June 2015 (#6 of 13) — 4 Comments

  1. Thanks for the reply. just after I posted I found another sound that was somehow switched around. I have managed to re-assign them to what they should say as follows; My “Amber” file has 0132 as millions and Meters as 0126. It also has 0146 as minutes and not dB which should be either 0137 or 0138. I have changed the file names so that my transmitter now makes sense. I can only think that somehow the Amber System files don’t match my version of the transmitter files. Anyhow it is not much of a problem to do a bit of re-naming. Thanks again for the site and your help. Russ

  2. Love this site.
    OK now the question; I have loaded the Amber sound pack however there is one small issue concerning the reading out of altitude. When I trigger the switch for the altitude, Amber says millions instead of meters. The written indication is 45m which Amber says is 45 million. I suspect I may have to change the name of the file that points to “meters” as “m” seems to call up millions, however I can’t seem to find it in the sounds folder. Perhaps there is somewhere else to look.
    Thanks for your help in advance.
    Russ

    • Hi, Russell!

      Check out the SOUNDS/en/SYSTEM folder, file 0132.wav. It’s the “meters” file. Not sure why it comes up as “millions” for you.

      Hope this helps!

      Leonard

Leave a Reply